The BZB BreadBoard with Built In Arduino compatible microcontroller is currently available at the
BZCORE TECHNOLOGIES KICKSTARTER PROJECT PAGE
Here is a gallery of the CINR beta breadboard, these photos are of version 1.0 which has been updated and superseded, but the full redesign of the circuit side of the project did not change the footprint or connection points of the 4 boards, board 4 (CINR-OUTRGR) is not in this gallery.
The 4 boards are:
CINR-PWRCOM or Power and Communications, which provides a 5v regulated power supply and an USB serial interface using a FTDI, which can be used as an external serial interface with an extension cable or compatible pin configuration on the FTDI out.
CINR-CONPROC or Connections and Processor, which provides an ATMEGA328 arduino processor with IO connections for the breadboard through hole interface and a shield extension board interface.
CINR-CTRLIO or Control Input and Output, provides a reset button and a led connected through the PWRCOM board to the CONPROC arduino reset circuit and digital 13(for blinking and status) respectively. The CNTRLIO also supplies, connected to PWRCOM, status LEDs for the power supply and the serial RX and TX lines.
CINR-OUTRGR or Outrigger is an extension board which uses the 28 pin header on the CONPROC board and formats an Arduino shield stack compatible output footprint to connect shields to the breadboard.
Hope this give a better view of how it all works together.